Arkray Glucocard X-Meter Manual do Utilizador descarregar pdf (Página 29)

- -

* If you choose “Yes” for automatic saving of meter data when you register basic information,

the received data are automatically saved and <Received data display> is not shown on the

screen.

* In this software, meter data displayed as “Lo” and “Hi” correspond to the following.

Meter data Corresponding value (mg/dL) Corresponding value (mmol/L)

Hi 600 33.3

Lo 10 0.6

Contents of <Received data display>

 Average/Median/Max val/Min val/Data count

Average/Median/Max value/Minimum value/Data count of received data are displayed.

*Data with marks such as “delete”, “control” or “temperature abnormality, which are not

to be analyzed, are not included in calculation.

 No

Numbers of measured data. No.1 means the oldest measured data.

* Disconnect the cable from the meter after you finish data reception so that the

transmission may not start again.

* While <Completed reception> is being displayed (approx. 20 seconds), your computer

cannot receive any data from the meter.

* When the received data seem wrong, check the measured data by calling memory of

the meter.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 67 68

Sem comentários

Arkray Glucocard X-Meter Manual do Utilizador Página 29